The operating process of the ice making machine

1、be sure the power is connected correctly and turn on the  machine,the machine start to run(the switch of the split machine is on the power box inside of the machine,and it’s set to be turned on always,control the plug to turn off the machine,it’s not necessary to open the control panel each time.)

2、the ice making system starts:when truning on the machine,keep the water inlet valve opening,then the water flows into the machine,the compressor starts,and it will keep running all the way during the whole ice making process.The cooling wind machine is controlled by the cooling pressure,so it can be opened and shut down cycling.

3、the pre-cooling process:the evaporator will be cooled 30s before the water get here,during the pre-cooling time,the water pump stops running,the water inlet valve keeps running till the water level sensor(floating ball)tells to stop.

4、ice making process:after 30s pre-cooling,the water pump restart,the continuous water flow into the ice mould smoothly,when the thickness of the ice block is thick enough to reaches the setting value,the continuous water keep touching the pin sensor on the ice board around 30s,the ice harvesting process start.

5、the harvest process:the hot air valve turns on,the water pump stop,the hot air enters into the evaporator,and after 1-2 minutes,the ice blocks strip off and drop down from the evaporator,when the ice blocks drop down,they will make the ice prevent board turn over,and turn on the spring switch,and after the drop down from the evaporator,when the ice blocks drop down,they will make the ice prevent board turn over,and turn on the spring switch,and after the

Adjusting the thickness of the ice block

1、Normally the distance between the ice thickness sensor and the evaporator should be 4mm-7mm.

2、screw the adjusting screw clockwise to add the thickness of the ice blocks,counterclockwise to decrease.

3、screw the adjusting screw 120 degree,the thickness changes 1.5mm.

4、inspect the connecting wire and the shelf to keep them being turned freely,make sure they can get back their position after each ice block harvest process.